Siemens SINUMERIK 840D sl Series Diagnostics Manual page 197

08/2005
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14125
Channel %1 block %2 programmed rotation is not possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed rotation of tool orientation cannot be traversed.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14126
Channel %1 block %2 ORIPATH lift factor impermissible.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The value programmed with ORIPLF = r is not within the permissible range. The relative
retraction factor must lie within interval 0 <= r < 1.
Reactions: - Correction block is reorganized.
- Interpreter stop
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14127
Channel %1 block %2 rotation programmed several times
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The rotation (3rd degree of freedom of orientation at six-axis transformations) has been
programmed several times.
The rotation is clearly defined by one of the following specifications:
• Specification of the rotary axis positions included in the transformation
• Specification of Euler or RPY angles (A2, B2, C2)
• Specification of the normal orientation vector (AN3, BN3, CN3)
• Specification of the THETA angle of rotation
Reactions: - Correction block is reorganized.
- Interpreter stop
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14128
Channel %1 block %2 absolute programming of the orienting rotation with active
ORIROTC.
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-197