Siemens SINUMERIK 840D sl Series Diagnostics Manual page 445

08/2005
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61115
Channel %1 Block %2: Approach or retract mode(straight / circle / plane / space)
incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The approach or retract mode to/from the contour has been incorrectly defined. Alarm
triggered by following cycle: CYCLE72.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Check parameter _AS1 or _AS2.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61116
Channel %1 Block %2: Approach or retract path = 0
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The approach or retract path has been specified with zero. Alarm triggered by following
cycle: CYCLE72.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Check parameter _LP1 or _LP2.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61117
Channel %1 Block %2: Active tool radius <= 0
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The radius of the acive tool is negative or zero. Alarm triggered by following cycles:
CYCLE71, POCKET3, POCKET4.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Modify radius.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61118
Channel %1 Block %2: Length or width = 0
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The length or width of the milling area is illegal. Alarm triggered by following cycle:
CYCLE71.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-445