Siemens SINUMERIK 840D sl Series Diagnostics Manual page 520

Overview of Alarms
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62923
Channel %1 block %2: Starting point not specified
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62924
Channel %1 block %2: Too many elements in the contour
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62925
Channel %1 block %2: Radius specified together with center point
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
62926
Channel %1 block %2: Wrong radius specified
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions:
Reactions: - Interpreter stop
- NC Start disable in this channel.
2-520
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005