Siemens SINUMERIK 840D sl Series Diagnostics Manual page 460

Overview of Alarms
Definitions: To be able to work with cutting speed, the tool radius has to be specified.
Alarm triggered by following cycles: E_DR_SIN, E_DR_TAP, E_TFS, F_DR_SIN,
F_DR_TAP, F_DRILLC, F_DRM_TA, F_TAP, F_TFS
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Enter a value for cutting speed.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61218
Channel %1 Block %2: Feed/tooth programmed, but number of tools equals zero
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: For feed per tooth, the number of teeth has to be specified.
Alarm triggered by following cycles: E_TFS, E_DR_BGF, F_TFS.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Enter the number of teeth on the milling tool in the "Tool list" menu.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61219
Channel %1 Block %2: Tool radius too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool radius is too large for machining.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select a suitable tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61220
Channel %1 Block %2: Tool radius too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool radius is too small for machining.
Alarm triggered by following cycles: CYCLE78.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select a suitable tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61221
Channel %1 Block %2: No tool active
2-460
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005