Siemens SINUMERIK 840D sl Series Diagnostics Manual page 440

Overview of Alarms
Remedy: Check and, if necessary, change the basic settings.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61014
Channel %1 Block %2: Return plane exceeded
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: CYCLE72.
Remedy: Check parameter RTP.
61015
Channel %1 Block %2: Contour is not defined
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: .
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61016
Channel %1 block %2: System frame for cycles missing
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: All measuring cycles can trigger this alarm.
Remedy: Set MD 28082: MM_SYSTEM_FRAME_MASK, Bit 5=1.
61017
Channel %1 block %2: function %4 not present in NCK
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: .
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61018
Channel %1 block %2: function %4 not executable with NCK
Parameters: %1 = Channel number
%2 = Block number, label channel number
Definitions: Alarm triggered by following cycles: .
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy:
2-440
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005