Siemens SINUMERIK 840D sl Series Diagnostics Manual page 121

08/2005
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10775
Channel %1 illegal tool change with face cutting in block %2
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: This alarm occurs when a tool change has been programmed while 3D tool radius com-
pensation is active with the result that the tool type changes or, if the tool type remains
unchanged, at least one relevant tool dimension has changed as compared with the
deselected tool. Depending on the tool type, relevant tool dimensions can be the tool
diameter, the rounding radius or the taper angle. Changes to the tool length are allowed.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10776
Channel %1 block%2 axis %3 must be geometry axis if tool radius compensation is
active
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: This alarm occurs when an axis that is required for tool radius compensation is not a
geometry axis. With CUT2DF, the axis can be a positioning axis perpendicular to the
machining plane; with all other types of compensation (CUT2DF, CUT3DC, CUT3DF,
CUT3DFF), all geometry axes must be operated as such.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
On selection of G41/42, the axes involved must be known as GEOAX in the channel. It is
possible by programming GEOAX() or G91 G0 X0 Y0 in the block prior to G41/42.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10777
Channel %1 block %2 tool radius compensation: too many blocks with suppres-
sion of compensation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The maximum permissible number of blocks with active compensation suppression with
tool radius compensation is limited by the machine data
CUTCOM_MAXNUM_SUPPR_BLOCKS.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-121