Siemens SINUMERIK 840D sl Series Diagnostics Manual page 104

Overview of Alarms
deactivating the extended monitoring (MD GANTRY_FUNCTION_MASK Bit0).
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform authorized personnel / the service department.
1. Remove a mechanical misalignment
2. Check axis (uneven mechanical movement?)
3. Delete MD GANTRY_ACT_POS_TOL_ERROR or deactivate the extended monitoring
4. MD 37120 GANTRY_POS_TOL_ERROR is set incorrectly
If the MD is changed, a power ON will be required.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10658
Channel %1 axis %2 impermissible axis status.
Parameters: %1 = Channel number
%2 = Error ID and gantry unit.
Definitions: %2 error ID and gantry unit
• %2 = 30XX => gantry group cannot be closed, as not all gantry axes
• %2 = 40XX => gantry group cannot be closed, as the gantry axes
• %2 = 50XX => gantry group is to change the channel due to a PLC request;
• %2 = 60XX => gantry group is to be transferred to channel due to an NC program
request,
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Error ID:
• %2 = 30XX => assign all gantry axes to the current channel, for example via axis
change.
• %2 = 40XX => set all axes of the gantry group to the same axis state,
• %2 = 50XX => make all gantry axes known to the required channel.
• %2 = 60XX => make all gantry axes known to the required channel.
:end
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10700
Channel %1 block %2 NCK protection zone %3 violated during automatic or MDA
mode
Parameters: %1 = Channel number
%2 = Block number
%3 = Protection zone number
Definitions: The workpiece-related NCK protection zone has been violated. Note that another tool-
related protection zone is still active. The workpiece-related protected area can be tra-
versed after a new NC Start.
2-104
are available in one channel.
have different axis states; the axis is assigned to the PLC, for example.
not all gantry axes are known in the new channel.
but the channel does not know all the gantry axes.
for example assign all axes to the NC program, or assign all axes to the PLC.
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005