Configuring Base Station Access Service (Gpon); E1 Base Station Access Service (In Native Tdm Mode); Service Requirement And Application Scenario - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End
Result
After the FTTM service configuration is complete, use the test meter to perform tests on the
ETH access port of the ONU and the upstream GE/10GE port of the OLT. The long-term bit
error ratio (BER) and delay should be able to meet the requirements for actual applications.

14.4 Configuring Base Station Access Service (GPON)

This topic describes how to configure the base station access service in GPON mode in different
networking scenarios.
Context
There are two xPON configuration modes: distributed mode (also called discrete mode) and
profile mode. The difference between the two modes lies in command lines.
l
l
Generally, the xPON configuration mode is determined in a new deployment and will not be
changed. This chapter describes how to configure the enterprise access service in PON profile
mode (which is the default mode). You can run the commands in the following table to query
the xPON configuration mode.
Mode
PON profile
mode
NOTE
For commands for the distributed configuration mode, see PON distributed-mode commands in the Command
Reference.

14.4.1 E1 Base Station Access Service (in Native TDM Mode)

ONUs transmit E1 signals of base stations to OLTs in Native TDM mode and OLTs are
interconnected with transmission equipment through E1/STM-1 ports. In this manner, traditional
circuit switching services can be carried over GPON networks.

14.4.1.1 Service Requirement and Application Scenario

Issue 01 (2014-04-30)
huawei(config)#clock bits-type 0 clock 2mhz
BITS clock parameter set successfully
huawei(config)#clock bits-type 0 time 1pps protocol ubx
BITS clock parameter set successfully
Distributed mode: In this mode, ONTs need to be configured one by one but not in batches.
Profile mode: In this mode, an ONT line profile and service profile are configured first.
Then, ONTs can be added in batches by binding profiles. This mode greatly improves
service provisioning efficiency.
Query Method
huawei(config)#diagnose
huawei(diagnose)%%display xpon mode
---------------------------------------------------
---------------------------------------------------
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
14 FTTM Configuration (Base Station Access)
Current config mode: Profile-mode
1399