End-To-End Configuration Process - Huawei OptiX OSN 550 Configuration Manual

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
Step 4 Check whether the services are configured correctly. For details, see Verifying the Correctness
of the SDH Service Configuration.
Step 5 Enable the performance monitoring function of the NEs. For details, see Setting Performance
Monitoring Parameters of an NE.
Step 6 Back up the configuration data of the NEs. For details, see Backing Up the NE Database to the
SCB Board.
----End
Relevant Task
If the services are configured incorrectly and need to be deleted, see Deleting SDH Services.

3.3.4 End-to-End Configuration Process

The configuration of the services on the non-protection ring is not related to the configuration
of the protection subnet. To configure the services on the non-protection ring, configure the SDH
services from the tributary board to the line board on the source and sink NEs and the pass-
through services on the intermediate NEs if the protection subnet is already created.
Prerequisite
l
l
l
l
Issue 02 (2011-06-30)
Parameter Value in
This
Example
Source 1-5
Timeslot
Range(e.g.
1,3-6)
Sink Slot 1-SL1D-1
(SDH-1)
Sink VC4 VC4-1
Sink 1-5
Timeslot
Range(e.g.
1,3-6)
Activate Yes
Immediately
The physical network topology must be set up.
The NEs, boards, and fibers must be successfully created on the U2000.
The protection subnet must be created and must be the same as the actual topology. For
details about how to create the protection subnet, see
Ring.
The operator must understand the information provided in
Allocation.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
In this example, five E1 services are configured between
NE1 and NE3. Hence, the service source occupies
VC-12s 1-5.
In this example, the SL1D board in slot 1 of NE2 is
configured as the sink line board. See
The service sink uses the timeslots of VC4-1.
In this example, five E1 services are configured between
NE1 and NE3. Hence, the service source occupies
VC-12s 1-5.
-
2.6.2 Configuring a Non-Protection
3 Configuring SDH Services
Figure 3-4.
3.3.2 Signal Flow and Timeslot
3-13