Send Mode (Ethernet Test) - Huawei OptiX OSN 550 Configuration Manual

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
Relationship with Other Parameters
None.

7.101 Send Mode (Ethernet Test)

Description
Send Mode(Ethernet Test) is used to set the test frame and the transmit mode of the test frame.
The test frame is used for simulating packet transmission to check whether the link is normal.
Impact on the System
The system operation is not affected.
Values
Valid Values
Disabled, Burst Mode, Continue Mode
The following table lists the description of each value.
Value
Disabled
Burst Mode
Continue Mode
Configuration Guidelines
Set this parameter according to the requirements of the test.
l
l
Relationship with Other Parameters
None..
Issue 02 (2011-06-30)
To perform the test continuously, set the parameter to Continue Mode.
To stop the test, set the parameter to Disabled.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Indicates the test is not performed.
Indicates that the system transmits a test frame every one
second. The test ends after a specified number of test frames
are transmitted.
Indicates that the system continuously transmits test frames
with a frequency of 1 frame per second.
7 List of Parameters
Default Value
Disabled
7-81