Creating Nes In Batches - Huawei OptiX OSN 550 Configuration Manual

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
Result
After an NE is successfully created, the system automatically saves the information, such as the
IP address, NSAP address, subnet mask, and NE ID to the U2000 database.
Follow-up Procedure
if you fail to log in to the created NE, the possible causes are listed as follows:
l
l

2.1.2 Creating NEs in Batches

When the U2000 communicates with the gateway NE normally, you can create NEs in batches
by searching for all the NEs that communicate with the gateway NE according to the IP address
of the gateway NE, the network segment to which the IP address of the gateway NE belongs, or
the NSAP addresses of the NEs. This method is quicker and more accurate than manual creation.
Prerequisite
l
l
l
Procedure
Step 1 Choose File > Discovery > NE from the Main Menu. Then, the NE Discovery window is
displayed.
Step 2 Choose Transport NE Search tab, Click Add. Then, the Input Search Domain dialog box is
displayed.
Step 3 Set Address Type to IP Address Range of GNE, IP Address of GNE, or NSAP Address.
Enter Search Address. Then, Click OK.
Issue 02 (2011-06-30)
The communication between the U2000 and the NE is abnormal. In this case, check the
settings of communication parameters, such as the IP address and ID of the NE.
The NE user is invalid. Change to use a valid NE user.
You must be an NM user with "NE administrator" authority or higher.
The U2000 must communicate with the gateway NE normally.
The NE Explorer instance of the NEs must be created.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Creating the Network
2-5