Huawei OptiX OSN 550 Configuration Manual page 220

4 Configuring Ethernet Services
4-66
Parame Value in This Example Description
ter
Mappin VCTRUNK1: GFP
g
VCTRUNK2: GFP
Protocol
Scrambl VCTRUNK1:
e Scrambling mode [X43
+1]
VCTRUNK2:
Scrambling mode [X43
+1]
Check VCTRUNK1: FCS32
Field
VCTRUNK2: FCS32
Length
FCS VCTRUNK1: Big endian
Calculat
VCTRUNK2: Big endian
ed Bit
Sequenc
e
Set VCTRUNK1: No
Inverse
VCTRUNK2: No
Value
for CRC
l Click the Bound Path tab. Click the Configuration button. Set the following
parameters in the Bound Path Configuration dialog box that is displayed. Then, click
Apply.
User Paramete
r
User C1 Configurab
le Ports
←→
user C2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
Mapping Protocol of the VCTRUNKs on
the Ethernet boards of the interconnected
equipment at both ends must be set to the
same value.
In this example, this parameter adopts the
default value Scrambling mode [X43+1].
In this example, this parameter adopts the
default value FCS32. Check Field Length
of the VCTRUNKs on the Ethernet boards of
the interconnected equipment at both ends
must be set to the same value.
When Mapping Protocol is set to GFP, FCS
Calculated Bit Sequence is set to Big
endian. FCS Calculated Bit Sequence of
the VCTRUNKs on the Ethernet boards of
the interconnected equipment at both ends
must be set to the same value.
When Mapping Protocol is set to GFP, this
parameter is valid and adopts the default
value -. Set Inverse Value for CRC of the
VCTRUNKs on the Ethernet boards of the
interconnected equipment at both ends must
be set to the same value.
Value in Description
This
Example
VCTRUN As shown in
K1 used by the service between user C1 and user
C2.
Configuration Guide
Figure 4-27, VCTRUNK1 is
Issue 02 (2011-06-30)
System