Huawei OptiX OSN 550 Configuration Manual page 242

4 Configuring Ethernet Services
2.
4-88
l Click the Advanced Attributes tab. The parameters in the Advanced Attributes tab
page adopt the default values.
Set the attributes of the internal ports (VCTRUNK1 and VCTRUNK2 of the EFS8 board)
used by the services of user F2 and user F3 on NE1.
l Select Internal Port.
l Click the TAG Attributes tab. After setting the parameters, click Apply.
Parame Value in This Example Description
ter
Entry VCTRUNK1: Enabled
Detectio
VCTRUNK2: Enabled
n
TAG VCTRUNK1: Tag Aware
VCTRUNK2: Tag Aware
Default -
VLAN
ID
VLAN -
Priority
l Click the Network Attributes tab. After setting the parameters, click Apply.
Parame Value in This Example Description
ter
Port VCTRUNK1: UNI
Attribut
VCTRUNK2: UNI
es
l Click the Encapsulation/Mapping tab. After setting the parameters, click Apply.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
If the packets of user F2 and user F3 carry
VLAN tags, you need to enable the entry
detection function to detect the VLAN tags
of the packets. In this example, Entry
Detection is set to Enabled.
The service access equipment of user F2 and
user F3 supports VLANs and the transmitted
data frames carry VLAN tags. In this
example, Tag is set to Tag Aware for
VCTRUNK1 and VCTRUNK2.
When TAG is set to Tag Aware, you need
not set Default VLAN ID.
When TAG is set to Tag Aware, you need
not set VLAN Priority.
UNI indicates the user-network interface,
namely, the interface of the service provider
located near the user side. The UNI interface
processes the tag attribute of IEEE 802.1Q-
compliant packets. That is, the UNI interface
processes and identifies the VLAN
information of the accessed user packets,
according to the supported tag flags, namely
Tag Aware, Access, and Hybrid.
System
Configuration Guide
Issue 02 (2011-06-30)