Huawei OptiX OSN 550 Configuration Manual page 112

3 Configuring SDH Services
2.
3-30
Parameter Value in
This
Example
Level VC12
Direction Unidirectio
nal
Source Slot 3-SP3D
Source VC4 -
Source 1-5
Timeslot
Range(e.g.
1,3-6)
Sink Slot 1-SL1D-1
(SDH-1)
Sink VC4 VC4-1
Sink 1-5
Timeslot
Range(e.g.
1,3-6)
Activate Yes
Immediately
Configure unidirectional pass-through services on NE2.
Click , and select NE2 from the displayed NE Navigator. Click OK.
Parameter Value in
This
Example
Level VC12
Direction Unidirection
al
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
Description
In this example, E1 services are configured. Hence,
Level of the E1 services is set to VC12.
In this example, the services are transmitted and
received on different paths. That is, the services are
unidirectional services. Hence, Direction of the
services is set to Unidirectional.
In this example, the SP3D board in slot 3 is configured
as the source tributary board for the unidirectional
services from NE1 to NE2. See
-
The total capacity of the services is 5xE1 according to
the plan. Hence, Source Timeslot Range(e.g.1,3-6)
is set to 1-5.
In this example, the SL1D board in slot 1 is configured
as the sink line board. See
In this example, the services require five VC-12s.
Sink VC4 is set to VC4-1, because a VC-4 contains
63 VC-12s.
The total capacity of the services is 5xE1 according to
the plan. Hence, Sink Timeslot Range(e.g.1,3-6) is
set to 1-5.
-
Description
In this example, E1 services are configured. Hence,
Level of the E1 services is set to VC12.
In this example, the services are transmitted and received
on different paths. That is, the services are unidirectional
services. Hence, Direction of the services is set to
Unidirectional.
System
Configuration Guide
Figure 3-10.
Figure 3-10.
Issue 02 (2011-06-30)