End-To-End Configuration Process - Huawei OptiX OSN 550 Configuration Manual

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
Step 6 Check whether the services are configured correctly. For details, see Verifying the Correctness
of the SDH Service Configuration.
Step 7 Enable the performance monitoring function of the NEs. For details, see Setting Performance
Monitoring Parameters of an NE.
Step 8 Back up the configuration data of the NEs. For details, see Backing Up the NE Database to the
SCB Board.
----End
Relevant Task
If the services are configured incorrectly and thus need to be deleted, see Deleting SDH Services.

3.9.4 End-to-End Configuration Process

Before configuring services on an SNCP ring with a non-protection chain, familiarize yourself
with the information about the source slot, sink slot, and their corresponding timeslots of the
working service and protection service on the source and sink NEs on the SNCP ring. You also
need to configure pass-through services on the intersecting NE. The following part describes
how to configure services on an SNCP ring with a non-protection chain in an end-to-end manner.
Prerequisite
l
l
l
l
Procedure
Step 1 Create a working VC-4 server trail.
Issue 02 (2011-06-30)
Parameter Value in
This
Example
Sink Slot 2-SL1D-1
(SDH-1)
Sink VC4 VC4-1
Sink 1-5
Timeslot
Range(e.g.
1,3-6)
Activate Yes
Immediately
The physical network topology must be set up.
NEs, boards, and fibers must be successfully created on the U2000.
A protection subnet must be created and must be the same as the actual topology. For details
about how to create a protection subnet, see
The operator must understand the information provided in
Allocation.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
In this example, the SL1D board in slot 2 of NE5 is
configured as the sink line board. See
In this example, the service sink uses the timeslots of
VC4-1.
In this example, five E1 services are configured between
NE3 and NE5. Hence, the service sink occupies VC-12s
1-5.
-
2.6.1 Configuring a Non-Protection
3 Configuring SDH Services
Figure 3-16.
3.9.2 Signal Flow and Timeslot
Chain.
3-59