Huawei OptiX OSN 550 Configuration Manual page 256

4 Configuring Ethernet Services
4-102
Parame Value in This Example Description
ter
Enabled PORT1: Enabled
/
PORT2: Enabled
Disable
d
Workin PORT1: Auto-
g Mode Negotiation
PORT2: Auto-
Negotiation
Maximu PORT1: 1522
m
PORT2: 1522
Frame
Length
MAC PORT1: Non-Loopback
Loopba
PORT2: Non-Loopback
ck
PHY PORT1: Non-Loopback
Loopba
PORT2: Non-Loopback
ck
l Click the Flow Control tab. The parameters in the Flow Control tab page adopt the
default values.
l Click the TAG Attributes tab. After setting the parameters, click Apply.
Parame Value in This Example Description
ter
Entry PORT1: Enabled
Detectio
PORT2: Enabled
n
TAG PORT1: Access
PORT2: Access
Default PORT1: 100
VLAN
PORT2: 200
ID
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
In this example, PORT1 and PORT2 carry
the services and are set to Enabled.
In this example, the Ethernet service access
equipment of user G1 and user H1 supports
the auto-negotiation mode. Hence, Working
Mode is set to Auto-Negotiation for PORT1
and PORT2.
Generally, this parameter adopts the default
value 1522.
The MAC loopback setting is used for fault
diagnosis. In this example, MAC
Loopback is set to Non-Loopback.
The PHY loopback setting is used for fault
diagnosis. In this example, PHY Loopback
is set to Non-Loopback.
The packets of user G1 and user H1 do not
carry VLAN tags. You need to enable the
entry detection function to detect whether the
packets carry VLAN tags. In this example,
Entry Detection is set to Enabled.
If the service access equipment of user G1
and user H1 does not support VLANs and if
the transmitted packets do not carry VLAN
tags, TAG is set to Access for PORT1 and
PORT2.
According to the plan, the VLAN ID is set to
100 on the transmission network side for
EVPLAN services between user G1, user G2,
and user G3. The VLAN ID is set to 200 on
the transmission network side for EVPLAN
services between user H1, user H2, and user
H3. In this case, the service data is isolated.
System
Configuration Guide
Issue 02 (2011-06-30)