Creating A Topology Subnet; Configuring The Protection Subnet - Huawei OptiX OSN 550 Configuration Manual

2 Creating the Network
Procedure
Step 1 Right-click in the blank area of the Main Topology and choose New > Link from the shortcut
menu. Then, the Create Link dialog box is displayed.
Step 2 Choose Fiber/Cable > Cable from the left pane.
Step 3 Enter the cable attributes in the panel on the right.
Step 4 Click OK. The cable that is already created between the U2000 and the gateway NE is displayed
on the Main Topology.
----End

2.5 Creating a Topology Subnet

To facilitate network management, you can assign the topology objects in the same network area
or with similar attributes into the same topology subnet.
Prerequisite
You must be an NM user with "NM operator" authority or higher.
Background Information
A topology subnet is created only to simplify the user interface and does not affect the operation
of the NEs.
Procedure
Step 1 Right-click in the blank area of the Main Topology and choose New > Subnet from the shortcut
menu.
Step 2 Click the Property tab in the Create Physical Subnet dialog box. Set the attributes of the subnet.
Step 3 Click the Select Objects tab. Select the created NEs or subnet from the Available Objects
column. Click
NOTE
Step 4 Click OK.
----End

2.6 Configuring the Protection Subnet

The OptiX OSN equipment supports various network level protection schemes, including the
linear MSP.
2-14
to add the selected objects to the Selected Objects column.
The information about the
provided as follows:
l indicates adding the selected objects from the left column to the right column.
l indicates adding all the objects from the left column to the right column.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
signs in a similar dialog box for selecting objects is
System
Configuration Guide
Issue 02 (2011-06-30)