Huawei OptiX OSN 550 Configuration Manual page 263

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
4.
Issue 02 (2011-06-30)
Parameter Value in
This
Example
Board NE1-4-EFS8 -
VB Name VB1
VB Type 802.1q
Bridge IVL/Ingress
Switch Mode Filter Enable
Bridge IVL
Learning
Mode
Ingress Filter Enabled
MAC Enabled
Address Self-
Learning
l Click Configure Mount.
l In Available Mounted Ports, select PORT1, PORT2, VCTRUNK1, VCTRUNK2,
VCTRUNK3, and VCTRUNK4. Then, click
l OK.
l In the Create Ethernet LAN Service dialog box, click OK.
Create a VLAN filtering table.
l Select the created bridge and click the VLAN Filtering tab.
l Click New.
l Create the VLAN filtering table for user G1, user G2, and user G3.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuring Ethernet Services
Description
This parameter is a character string used to describe
the bridge. It is recommended that you set this
parameter to a character string that contains the
information about the detailed application of the
bridge.
IEEE 802.1q bridge supports isolation by using one
layer of VLAN tags. This bridge checks the contents
of the VLAN tags that are in the packets and
performs Layer 2 switching according to the
destination MAC addresses and the VLAN IDs of
the packets.
When the bridge adopts the IVL learning mode, the
entry in the MAC address table is created according
to the source MAC address, VLAN ID, and source
port of the data frame. The entry is not valid for all
the VLANs..
-
This parameter checks the validity of VLAN tags. If
the VLAN ID is not the same as the VLAN ID
defined in the VLAN filtering table, the data frame
is discarded.
-
.
4-109