Table 2-8 Parameters For Configuring Orderwire Phones - Huawei OptiX OSN 550 Configuration Manual

2 Creating the Network

Table 2-8 Parameters for configuring orderwire phones

Field
Call Waiting Time(s)
Dialing Mode
Conference Call
Phone 1, Phone 2, Phone 3
2-38
OptiX OSN 550 Multi-Service CPE Optical Transmission
Value Range
1-9
Default value: 9
Pulse, Dual-Tone Frequency
Default: Dual-Tone
Frequency
100-99999999
Default value: 999
100-99999999
NOTE
OptiX OSN 550 equipment
only supports Phone 1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
System
Configuration Guide
Description
The Call Waiting Time(s)
parameter specifies the
timeout period of searching
an orderwire route. If the
period of searching an
orderwire route exceeds the
specified value, the
orderwire phone changes to
the busy tone status.
You can click 7.102 Call
Waiting Time(s) to display
the detailed information.
Displays the dialing mode of
the orderwire phone.
The Conference Call
parameter specifies the
phone numbers of
networkwide orderwire calls.
You can click 7.103
Conference Call to display
the detailed information.
The Phone parameter
specifies the phone numbers
of orderwire addressing calls.
An addressing call refers to a
point-to-point call.
Specifies the phone numbers
of up to three orderwire
phones supported by the
overheads. Certain
equipment supports one
orderwire phone only. In this
case, phones 2 and 3 are not
required. If the value is null,
the delivered configuration
does not indicate that the
corresponding data on the NE
side needs to be cleared, but
indicates that the
corresponding data on the NE
side is not changed.
You can click 7.104 Phone
display the detailed
information.
Issue 02 (2011-06-30)
to