Figure 4-32 Networking Diagram For Configuring Evplan Services (Ieee 802.1Q Bridge) - Huawei OptiX OSN 550 Configuration Manual

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
4.9.1 Networking Diagram
The convergence node needs to exchange Ethernet services with two access nodes at Layer 2.
LAN services of the two users (H and G) need to be isolated.
Service Requirement
In the network shown in
l
l
l
l

Figure 4-32 Networking diagram for configuring EVPLAN services (IEEE 802.1q bridge)

NE2:
Line board Ethernet board Ethernet board
6-SL4D-2
Board Configuration Information
For the EVPLAN (IEEE 802.1q bridge) services supported by Ethernet switching boards, refer
to Table
Issue 02 (2011-06-30)
Figure
Three branches (G1, G2, and G3) of user G are located at NE1, NE2, and NE4 respectively.
The branches need to form a LAN and share a 10 Mbit/s bandwidth. G2 and G3 do not
need to communicate with each other.
Three branches (H1, H2, and H3) of user H are located at NE1, NE2, and NE4 respectively.
The branches need form a LAN and share a 20 Mbit/s bandwidth. H2 and H3 need to
communicate with each other.
The service of user G needs to be isolated from the service of user H.
The Ethernet equipment of user G and user H provides 100 Mbit/s Ethernet electrical
interfaces that work in auto-negotiation mode and do not support VLANs.
3-EGT1
4-EGT1
NM
3-EGT1-PORT1
H2
4-EGT1-PORT1
6-SL4D-2
G2
H1
VCTRUNK
VB1
VCTRUNK3
PORT2
6-1.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-32, the service requirements are as follows:
NE3
NE2 NE4
NE1
6-SL4D-1
6-SL4D-2
PORT2
PORT1
VB1
VLAN 200
VCTRUNK1
VCTRUNK4
4 Configuring Ethernet Services
NE4:
Line board Ethernet board
Ethernet board
6-SL4D-1 4-EGT1
3-EGT1-PORT1
H3
4-EGT1-PORT1
G3
6-SL4D-1
G1
NE1:
Line board
Ethernet board
4-EFS8 6-SL4D-1
VLAN 100
VCTRUNK2
PORT1
3-EGT1
Line board
6-SL4D-2
4-97