Huawei OptiX OSN 550 Configuration Manual page 257

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
2.
Issue 02 (2011-06-30)
Parame Value in This Example Description
ter
VLAN 0
Priority
l Click the Advanced Attributes tab. The parameters in the Advanced Attributes tab
page adopt the default values.
Set the attributes of the internal ports (VCTRUNK1, VCTRUNK2, VCTRUNK3, and
VCTRUNK4 on the EFS8 board) used by the service between user G1 and user G2, the
service between user G1 and user G3, the service between user H1 and user H2, and the
service between user H1 and user H3.
l Select Internal Port.
l Click the TAG Attributes tab. After setting the parameters, click Apply.
Parame Value in This Example Description
ter
Entry VCTRUNK1: Enabled
Detectio
VCTRUNK2: Enabled
n
VCTRUNK3: Enabled
VCTRUNK4: Enabled
TAG VCTRUNK1: Access
VCTRUNK2: Access
VCTRUNK3: Access
VCTRUNK4: Access
Default VCTRUNK1: 100
VLAN
VCTRUNK2: 100
ID
VCTRUNK3: 200
VCTRUNK4: 200
VLAN VCTRUNK1: 0
Priority
VCTRUNK2: 0
VCTRUNK3: 0
VCTRUNK4: 0
l Click the Network Attributes tab. After setting the parameters, click Apply.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuring Ethernet Services
This parameter adopts the default value.
The packets of user G2, user G3, user H2, and
user H3 do not carry VLAN tags. You need
to enable the entry detection function to
detect the VLAN tags of the packets. In this
example, Entry Detection is set to
Enabled.
If the service access equipment of user G2,
user G3, user H2, and user H3 does not
support VLANs and if the transmitted
packets do not carry VLAN tags, TAG is set
to Access for the four VCTRUNKs.
According to the plan, the VLAN ID is set to
100 on the transmission network side for
EVPLAN services between user G1, user G2,
and user G3. The VLAN ID is set to 200 on
the transmission network side for EVPLAN
services between user H1, user H2, and user
H3. In this case, the service data is isolated.
This parameter adopts the default value.
4-103