Huawei OptiX OSN 550 Configuration Manual page 202

4 Configuring Ethernet Services
2.
4-48
l Click the Flow Control tab. The parameters in the Flow Control tab page adopt the
default values.
l Click the TAG Attributes tab. After setting the parameters, click Apply.
Parame Value in This Example Description
ter
TAG PORT1: Access
PORT2: Access
Default PORT1: 1
VLAN
PORT2: 1
ID
VLAN PORT1: 0
Priority
PORT2: 0
Entry PORT1: Disabled
Detectio
PORT2: Disabled
n
l Click the Advanced Attributes tab. The parameters in the Advanced Attributes tab
page adopt the default values.
Set the attributes of the internal ports (VCTRUNK1 and VCTRUNK2 of the EFS8 board)
used by the services of user A1 and user B1.
l Select Internal Port.
l Click the TAG Attributes tab. After setting the parameters, click Apply.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
The access equipment of user A1 and user B1
does not support the VLAN. Hence, the
access equipment transmits only the packet
without the VLAN tag. In this example, it is
recommended that you set the TAG flags at
PORT1 and PORT2 to Access.
The services of user A1 and user B1
exclusively occupy the PORTs and
VCTRUNKs. Hence, the VLAN ID is not
required for isolating the services. In this
example, Default VLAN ID adopts the
default value.
Both the VLAN ID and VLAN priority are
unnecessary for users A1 and B1. In this
example, VLAN Priority adopts the default
value.
The services of user A1 and user B1 are EPL
transparent transmission services. Hence,
you need not enable the entry detection
function to check the VLAN tags of the
packets. In this example, Entry Detection
need to be set to Disabled. When Entry
Detection is set to Disabled, the parameters
of TAG, Default VLAN ID, and VLAN
Priority are invalid.
System
Configuration Guide
Issue 02 (2011-06-30)