OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
Step 3 See Setting Network-Wide Performance Monitoring and enable the performance monitoring
function of the NEs.
Step 4 Back up the configuration data of the NEs. For details, see Backing Up the NE Data to the System
Control Board.
----End
2.11 Configuring the F1 Data Service
The F1 data service is transparently transmitted in the point-to-point mode by using the F1 byte.
Prerequisite
l
l
Procedure
Step 1 In the NE Explorer, select NE1 and choose Configuration > Orderwire from the Function Tree.
Step 2 Click the F1 Data Port tab. After setting the parameters, click Apply. For the principles of
setting the parameters, see
Step 3 Enable the performance monitoring function of the NEs. For details, see Setting Performance
Monitoring Parameters of an NE.
Step 4 Back up the configuration data of the NEs. For details, see Backing Up the NE Database to the
SCB Board.
----End
2.12 Orderwire Configuration Parameters
The equipment supports various orderwire management, which involves orderwire phones and
F1 data interfaces.
2.12.1 Configuring Orderwire Phones
This topic describes the parameters that are used for configuring orderwire phones.
2.12.2 Configuring F1 Data Interfaces
This topic describes the parameters that are used for configuring F1 data interfaces.
2.12.3 Configuring Broadcast Data Interfaces
This topic describes the parameters that are used for configuring broadcast data interfaces.
2.12.1 Configuring Orderwire Phones
This topic describes the parameters that are used for configuring orderwire phones.
Table 2-8
Issue 02 (2011-06-30)
The
2 Creating the Network
Understand the signal flow and timeslot allocation.
2.12.2 Configuring F1 Data
lists the parameters that are used for configuring orderwire phones.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
is completed.
Interfaces.
2 Creating the Network
2-37