Creating Fibers; Creating Fibers Automatically - Huawei OptiX OSN 550 Configuration Manual

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide

2.4 Creating Fibers

You can create fibers, serial port cables, extended ECC, and virtual fibers by using the U2000.

2.4.1 Creating Fibers Automatically

By using the fiber search feature, you can check whether a specified optical interface is connected
to a fiber. Then, you can quickly create a fiber for this optical interface on the U2000. In the
case of a newly created network, after configuring the boards on the U2000, you can search for
all the optical interfaces and then create the fibers on the entire network. In this way, you can
monitor the actual working status of each fiber.
2.4.2 Creating Fibers Manually
Before you configure services, you need to create the required fibers. You can create a small
number of fibers manually one after another.
2.4.3 Creating Virtual Fibers
When the U2000 manages the SDH, PTN, and WDM equipment at the same time, you can create
virtual fibers between the SDH or PTN equipment (with the WDM equipment in between), to
facilitate network management.
2.4.4 Creating DCN Communication Cable
The U2000 can communicate with NEs through the Ethernet port or serial port. The NEs can
also communicate with each other through the extended ECC. Depending on the communication
mode, different types of communication cables can be created on the U2000.
2.4.1 Creating Fibers Automatically
By using the fiber search feature, you can check whether a specified optical interface is connected
to a fiber. Then, you can quickly create a fiber for this optical interface on the U2000. In the
case of a newly created network, after configuring the boards on the U2000, you can search for
all the optical interfaces and then create the fibers on the entire network. In this way, you can
monitor the actual working status of each fiber.
Prerequisite
l
l
l
Precautions
l If conflicting fibers are detected during the creation, delete the conflicting fibers on the
U2000 before you start creating new fibers.
Issue 02 (2011-06-30)
Fibers must be connected to the optical interfaces of each NE.
The boards of each NE must be created on the U2000.
You must be an NM user with "NE maintainer" authority or higher.
CAUTION
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Creating the Network
2-11