Huawei OptiX OSN 550 Configuration Manual page 241

OptiX OSN 550 Multi-Service CPE Optical Transmission
System
Configuration Guide
Issue 02 (2011-06-30)
l Click the Basic Attributes tab. After setting the parameters, click Apply.
Parame Value in This Example Description
ter
Enabled PORT1: Enabled
/
Disable
d
Workin PORT1: Auto-
g Mode Negotiation
Maximu PORT1: 1522
m
Frame
Length
MAC PORT1: Non-Loopback
Loopba
ck
PHY PORT1: Non-Loopback
Loopba
ck
l Click the Flow Control tab. The parameters in the Flow Control tab page adopt the
default values.
l Click the TAG Attributes tab. After setting the parameters, click Apply.
Parame Value in This Example Description
ter
Entry PORT1: Enabled
Detectio
n
TAG PORT1: Tag Aware
Default -
VLAN
ID
VLAN -
Priority
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Configuring Ethernet Services
In this example, PORT1 carries the services
and is set to Enabled.
The Ethernet service access equipment of
user F1 supports the auto-negotiation mode.
In this example, Working Mode is set to
Auto-Negotiation.
Generally, this parameter adopts the default
value 1522.
The MAC loopback setting is used for fault
diagnosis. In this example, MAC
Loopback is set to Non-Loopback.
The PHY loopback setting is used for fault
diagnosis. In this example, PHY Loopback
is set to Non-Loopback.
If the packets of user F1 carry VLAN tags,
you need to enable the entry detection
function to detect the VLAN tags of packets.
In this example, Entry Detection is set to
Enabled.
The service access equipment of user F1
supports VLANs and the transmitted data
frames carry VLAN tags. In this example,
Tag is set to Tag Aware for PORT1.
When TAG is set to Tag Aware, you need
not set Default VLAN ID.
When TAG is set to Tag Aware, you need
not set VLAN Priority.
4-87