Huawei OptiX OSN 550 Configuration Manual page 306

4 Configuring Ethernet Services
Field
Encapsulation
Format
Port Enabled
Hub/Spoke
TAG
Default VLAN ID
Working Mode
Active
4-152
OptiX OSN 550 Multi-Service CPE Optical Transmission
Value Range
MartinioE, stack VLAN
Enabled, Disabled
Hub, Spoke
Default value: Hub
Access, Tag Aware, Hybrid
For example: 1
Auto-Negotiation, 10M
Half-Duplex, 10M Full-
Duplex, 100M Half-Duplex,
100M Full-Duplex, 1000M
Half-Duplex, 1000M Full-
Duplex, 10G Full-Duplex
LAN, 10G Full-Duplex
WAN
NOTE
l The EFS8 board supports
Auto-Negotiation, and
100M Full-Duplex.
For example: Active
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Configuration Guide
Description
Displays the encapsulation format for
a port of the P type.
NOTE
The OptiX OSN 550 does not support this
parameter.
Enables or disables a port.
l Enabled: This port can access
services.
l Disabled: This port cannot access
services.
Hub/Spoke (Ethernet LAN Service)
is used to separate packets between
the logical ports in the network
bridge.
In the same VB VLAN filter or plain
bridge:
l Communication is available
between ports configured with
Hub.
l Communication is available
between a port configured with
Spoke and a port configured with
Hub.
l Communication is unavailable
between ports both configured
with Spoke.
Set this parameter according to the
isolation domain range of the user.
Displays the tag attribute of the VB.
Displays the VLAN ID.
Displays the working modes of the
Ethernet port. Auto-Negotiation can
automatically determine the
optimized working modes of the
connected ports. This mode is easy to
maintain and is recommended.
During configuration, make sure that
working modes of the connected ports
are consistent. If the working modes
are different, the services are down.
Displays the activation status.
Issue 02 (2011-06-30)
System