Configuration Process; Table 4-29 Parameters Of Ethernet Lan Services (Ieee 802.1D Bridge) - Huawei OptiX OSN 550 Configuration Manual

4 Configuring Ethernet Services

Table 4-29 Parameters of Ethernet LAN services (IEEE 802.1d bridge)

Parameter
Board
VB Name
Bridge Type
Bridge Switch Mode
Bridge Learning Mode
Ingress Filter
VB Mount Port
Hub/Spoke

4.8.3 Configuration Process

At the convergence node NE1, you need to create an EPLAN service (IEEE 802.1d bridge). At
the access nodes NE2 and NE4, you need to configure only transparent transmission EPL
services.
Prerequisite
You must be familiar with
Background Information
If the Ethernet boards in the actual application scenarios are different from the boards in this
example, you need to learn about the requirements for configuring specific boards.
l
l
Procedure
Step 1 Configure the EPLAN services for users F1, F2, and F3 on NE1.
1.
4-86
PORT1
VCTRUNK1
VCTRUNK2
4.3.3 Flow of Configuring EPLAN
For the EPLAN services supported by Ethernet switching boards, see
Capability of Ethernet
For the VCTRUNK binding requirements of Ethernet switching boards, see
Requirements for Binding Paths with VCTRUNKs on Ethernet
Set the attributes of the external port (PORT1 of the EFS8 board) used by the service of
user F1.
l In the NE Explorer, select the EFS8 board, and then choose Configuration > Ethernet
Interface Management > Ethernet Interface from the Function Tree.
l Select External Port.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
OptiX OSN 550 Multi-Service CPE Optical Transmission
Ethernet LAN Service of NE1
EFS8
VB1
IEEE 802.1d
SVL/Ingress Filter Disable
SVL
Disabled
PORT1, VCTRUNK1, VCTRUNK2
Hub
Spoke
Spoke
Boards.
System
Configuration Guide
Services.
6.1 Service Support
6.2
Boards.
Issue 02 (2011-06-30)