Fba A Settings - ABB +N5600 Firmware Instructions

No. Name/Value
50.56 FBA B comm
supervision force
Bit Name
0 Ext 1
1 Ext 2
2 Local
3...15 Reserved
0000b...0111b
51

51 FBA A settings

51.01 FBA A type
51.02 FBA A Par2
0...65535
... ...
51.26 FBA A Par26
0...65535
51.27 FBA A par refresh
Done
Refresh
51.28 FBA A par table ver
51.29 FBA A drive type
code
0...65535
Description
Activates fieldbus communication monitoring separately for
each control location (see section
control on page 24).
The parameter is primarily intended for monitoring the
communication with FBA B when it is connected to the
application program and not selected as a control source by
drive parameters.
Value
1 = Communication monitoring active when Ext 1 is being used.
1 = Communication monitoring active when Ext 2 is being used.
1 = Communication monitoring active when local control is being
used.
FBA B communication monitoring selection.
Fieldbus adapter A configuration.
Displays the type of the connected fieldbus adapter module.
0 = Module is not found or is not properly connected, or is
disabled by parameter 50.01 FBA A
32 = FCAN; 37 = FDNA; 101 = FCNA, 128 = FENA-11/21;
135 = FECA; 136 = FEPL; 485 = FSCA.
This parameter is read-only.
Parameters 51.02...51.26
more information, see the documentation of the fieldbus
adapter module. Note that not all of these parameters are
necessarily in use.
Fieldbus adapter configuration parameter.
...
See parameter 51.02 FBA A
Fieldbus adapter configuration parameter.
Validates any changed fieldbus adapter module configuration
settings. After refreshing, the value reverts automatically to
Done.
Note: This parameter cannot be changed while the drive is
running.
Refreshing done.
Refreshing.
Displays the parameter table revision of the fieldbus adapter
module mapping file (stored in the memory of the drive).
In format axyz, where ax = major table revision number; yz =
minor table revision number.
This parameter is read-only.
Parameter table revision of adapter module.
Displays the drive type code in the fieldbus adapter module
mapping file (stored in the memory of the drive).
This parameter is read-only.
Drive type code stored in the mapping file.
Local control vs. external
enable; 1 = FPBA;
are adapter module-specific. For
Par2.
Parameters 381
Def/FbEq16
0000b
1 = 1
-
-
1 = 1
...
-
1 = 1
Done
0
1
-
-
-
1 = 1