ABB +N5600 Firmware Instructions page 399

No. Name/Value
60.23 M/F status
supervision sel 1
Bit Name
0 Follower 1
1 Follower 2
... ...
15 Follower 16
0000h...FFFFh
60.24 M/F status
supervision sel 2
Bit Name
0 Follower 17
1 Follower 18
... ...
15 Follower 32
0000h...FFFFh
Description
(This parameter is only effective when the drive is the master
on a D2D link. See parameters
port and 60.03 M/F mode.)
In the master, parameters
and 60.24 M/F status supervision sel 2
whose status word is monitored by the master.
This parameter selects the followers (out of followers 1...16)
whose status words are monitored by the master.
If a follower reports a fault (bit 3 of the status word is on), the
action specified in 60.17 Follower fault action
and 1 of the status word (ready states) are handled as
defined by 60.18 Follower
Using 60.27 M/F status supv mode sel 1
status supv mode sel 2, it is possible to define whether any
given follower is only monitored when it is stopped.
Note: Also activate communication supervision for the same
followers in parameter 60.19 M/F comm supervision sel
The status of communication is shown by
communication status 1
2.
Description
1 = Status of follower 1 is monitored.
1 = Status of follower 2 is monitored.
...
1 = Status of follower 16 is monitored.
D2D follower status supervision selection (followers 1...16).
Selects the followers (out of followers 17...32) whose status
words are monitored by the D2D master.
Note: Also activate communication supervision for the same
followers in parameter 60.20 M/F comm supervision sel
See parameter 60.23 M/F status supervision sel
Description
1 = Status of follower 17 is monitored.
1 = Status of follower 18 is monitored.
...
1 = Status of follower 32 is monitored.
D2D follower status supervision selection (followers 17...32).
60.01 M/F communication
60.23 M/F status supervision sel 1
specify the followers
is taken. Bits 0
enable.
and 60.28 M/F
62.37 M/F
and 62.38 M/F communication status
Parameters 399
Def/FbEq16
-
1.
1 = 1
-
2.
1.
1 = 1