ABB +N5600 Firmware Instructions page 485

No. Name/Value
96.29 Time sync source
status
Bit Name
0 Time tick
received
1 Aux Time
tick received
2 Tick interval
is too long
3 DDCS
controller
4 Master/
Follower
5 Reserved
6 D2D
7 FbusA
8 FbusB
9 EFB
10 Ethernet
11 Panel link
12 Ethernet tool
link
13 Parameter
setting
14 RTC
15 Drive On-
Time
0000h...FFFFh
96.31 Drive ID number
0...32767
96.53 Actual checksum
00000000h...
FFFFFFFFh
Description
Time source status word.
This parameter is read-only.
Description
1 = 1st priority tick received: Tick has been received from 1st priority
source.
1 = 2nd priority tick received: Tick has been received from 2nd priority
source.
1 = Yes: Tick interval too long (accuracy compromised).
1 = Tick received: Tick has been received from an external controller.
1 = Tick received: Tick has been received through the master/follower link.
1 = Tick received: Tick has been received through the drive-to-drive link.
1 = Tick received: Tick has been received through fieldbus interface A.
1 = Tick received: Tick has been received through fieldbus interface B.
1 = Tick received: Tick has been received through the embedded fieldbus
interface.
1 = Tick received: Tick has been received through the Ethernet port on type
BCU control unit.
1 = Tick received: Tick has been received from the control panel, or Drive
composer PC tool connected to the control panel.
1 = Tick received: Tick has been received from Drive composer PC tool
through an FENA module.
1 = Tick received: Tick has been set by parameters 96.24...96.26.
1 = RTC time in use: Time and date have been read from the real-time
clock.
1 = Drive on-time in use: Time and date are displaying drive on-time.
Time source status word 1.
Specifies an ID number for the drive. The ID can be read by
an external controller through DDCS, for example, for
comparison with an ID contained by the controller's
application.
ID number.
Displays the actual parameter configuration checksum. The
checksum is generated and updated whenever an action is
selected in 96.54 Checksum
The parameters included in the calculation have been pre-
selected, but the selection can be edited using the Drive
customizer PC tool.
See also section Parameter checksum calculation
126).
Actual checksum.
action.
(page
Parameters 485
Def/FbEq16
-
1 = 1
0
1 = 1
0h
-