User Lock; Data Storage Parameters - ABB +N5600 Firmware Instructions

Settings
Parameters 96.53...96.59


User lock

For better cybersecurity, it is highly recommended that you set a master pass code to
prevent eg. the changing of parameter values and/or the loading of firmware and
other files.
WARNING! ABB will not be liable for damages or losses caused by the failure
to activate the user lock using a new pass code. See
(page 19).
To activate the user lock for the first time,
• Enter the default pass code, 10000000, into
parameters 96.100...96.102
• Enter a new pass code into
digits; if using Drive composer, finish with Enter.
• Confirm the new pass code in
WARNING! Store the pass code in a safe place – the user lock cannot be
opened even by ABB if the pass code is lost.
• In 96.102 User lock
recommend you select all the actions unless otherwise required by the
application).
• Enter an invalid (random) pass code into
• Activate 96.08 Control board
• Check that parameters
random pass code into 96.02.
To reopen the lock, enter your pass code into
parameters 96.100...96.102
Settings
Parameters 96.02


Data storage parameters

Twenty-four (sixteen 32-bit, eight 16-bit) parameters are reserved for data storage.
These parameters are unconnected by default and can be used for eg. linking, testing
and commissioning purposes. They can be written to and read from using other
parameters' source or target selections.
(page 485).
visible.
96.100 Change user pass
96.101 Confirm user pass
functionality, define the actions that you want to prevent (we
boot, or cycle the power to the control unit.
96.100...96.102
visible.
(page 480) and 96.100...96.102
Program features 127
Cybersecurity disclaimer
96.02 Pass code. This will make
code. Always use eight
code.
96.02 Pass code.
are hidden. If they are not, enter another
96.02 Pass code. This will again make
(page 488).