ABB +N5600 Firmware Instructions page 474

474 Parameters
No. Name/Value
95.02 Adaptive voltage
limits
Disable
Enable
95.04 Control board
supply
Internal 24V
External 24V
Redundant external
24V
Description
Enables adaptive voltage limits.
Adaptive voltage limits can be used if, for example, an IGBT
supply unit is used to raise the DC voltage level. If the
communication between the inverter and the IGBT supply unit
is active (95.20 HW options word
related to the DC voltage reference transmitted to the supply
unit (94.20 DC voltage reference) assuming that the
reference is high enough. Otherwise, the limits are calculated
based on the measured DC voltage at the end of the pre-
charging sequence.
This function is also useful if the AC supply voltage to the
drive is high, as the warning levels are raised accordingly.
Adaptive voltage limits disabled.
Adaptive voltage limits enabled.
Specifies how the control unit of the drive is powered.
The default value depends on the type of the control unit and
the setting of parameter 95.20.
The drive control unit is powered from the drive power unit it
is connected to.
Note: If reduced run (see page 128) is required, select
External 24V or Redundant external 24V
The drive control unit is powered from an external power
supply. The drive power unit and power unit link faults are
masked when the drive is in stopped state, so the main circuit
can be powered down without faults while the control unit is
powered.
(Type BCU control units only) The drive control unit is
powered from two redundant external power supplies. The
loss of one of the supplies generates a warning
External power signal missing). The drive power unit and
power unit link faults are masked when the drive is in stopped
state, so the main circuit can be powered down without faults
while the control unit is powered.
1), the voltage limits are
instead.
(AFEC
Def/FbEq16
Disable
0
1
Internal 24V
(ZCU);
External 24V
(BCU;
95.20 b4)
0
1
2