Esp Signals - ABB +N5600 Firmware Instructions

No. Name/Value
09

09 ESP signals

09.01 ESP status word
Bit Name
0 Production state
1 Restart delay act
2 Backspin observer act Backspin speed observer routine is active.
3...4 Reserved
5 Kick-start act
6 Current pulse act
7 Underload act
8 Overload act
9...10 Reserved
11 Current boost/IR
comp. act
12 Cleaning act
13...14 Reserved
15 Time control act
09.09 Drive control state
Drive not ready
ID run undone
Drive stopped
Fault active
Local control
Jog mode
Ext1 running
Ext2 running
Stopping
Em stop active
Constant speed
09.11 Drive output current
0.00...30000.00 A
09.13 Motor current
estimated
0.00...30000.00 A
09.14 Motor current %
0.00...30000.00 %
09.15 Motor voltage
estimated
0.00...30000.00 V
09.21 Frequency
reference used
Description
ESP signals to monitor the pump.
Displays the current state of the ESP application functions.
Description
Drive is following the ESP program reference.
Restart delay timer active.
Kick-start starting routine is active.
Current-pulse starting routine is active.
Underload condition is active.
Overload condition is active.
Voltage or current boost is active.
Pump cleaning operation is active.
Time control is active.
Displays the current state of drive control.
Drive is not ready for operation.
No motor ID run done. Necessary to run in DTC mode.
Drive is stopped.
A fault is active.
Drive is in Local control.
Jogging enable signal is On.
Control location EXT1 is active.
Control location EXT2 is active.
Drive is stopping the motor as per deceleration ramp time
settings.
Stopping after receiving an emergency stop command.
Drive is running in constant speed mode.
Displays actual drive output current.
Drive output current.
Displays the actual motor current estimate based on
transformer ratio and sine-filter settings.
Estimated motor current.
Displays estimated actual motor current in %.
Estimated motor current.
Displays the actual motor voltage estimate based on
transformer ratio setting.
Estimated motor voltage.
Displays the frequency reference currently produced by the
ESP control program.
Parameters 183
Def/FbEq16
Drive not
ready
0
1
2
3
4
5
6
7
8
9
10
0.00
10 = 1A
0.00
10 = 1A
0.00
10 = 1%
0.00
10 = 1V
0.00