ABB +N5600 Firmware Instructions page 208

208 Parameters
No. Name/Value
14.14 DIO2 function
Output
Input
14.16 DIO2 output source
14.17 DI2 ON delay
0.00 ... 3000.00 s
14.17 DIO2 ON delay
0.00 ... 3000.00 s
14.18 DI2 OFF delay
0.00 ... 3000.00 s
14.18 DIO2 OFF delay
0.00 ... 3000.00 s
14.19 DIO3 function
Output
Input
14.19 AI supervision
function
No action
Fault
Warning
Last speed
Description
(Visible when 14.01 Module 1 type
Selects whether DIO2 of the extension module is used as a
digital input or output.
DIO2 is used as a digital output.
DIO2 is used as a digital input.
(Visible when 14.01 Module 1 type
Selects a drive signal to be connected to digital input/output
DIO2 when parameter 14.14 DIO2 function
For the available selections, see parameter
output source.
(Visible when 14.01 Module 1 type
Defines the activation delay for digital input DI2. See
parameter 14.12 DI1 ON
Activation delay for DI2.
(Visible when 14.01 Module 1 type
Defines the activation delay for digital input/output DIO2. See
parameter 14.12 DIO1 ON
Activation delay for DIO2.
(Visible when 14.01 Module 1 type
Defines the deactivation delay for digital input DI2. See
parameter 14.12 DI1 ON
Deactivation delay for DI2.
(Visible when 14.01 Module 1 type
Defines the deactivation delay for digital input/output DIO2.
See parameter 14.12 DIO1 ON
Deactivation delay for DIO2.
(Visible when 14.01 Module 1 type
Selects whether DIO3 of the extension module is used as a
digital input or output.
DIO3 is used as a digital output.
DIO3 is used as a digital input.
(Visible when 14.01 Module 1 type
Selects how the drive reacts when an analog input signal
moves out of the minimum and/or maximum limits specified
for the input.
The inputs and the limits to be observed are selected by
parameter 14.20 AI supervision
No action taken.
Drive trips on 80A0 AI supervision.
Drive generates an A8A0 AI supervision
Drive generates a warning
the speed (or frequency) to the level the drive was operating
at. The speed/frequency is determined on the basis of actual
speed using 850 ms low-pass filtering.
WARNING! Make sure that it is safe to continue
operation in case of a communication break.
= FIO-01 or FIO-11)
= FIO-01 or FIO-11)
is set to Output.
14.11 DIO1
= FDIO-01)
delay.
= FIO-01 or FIO-11)
delay.
= FDIO-01)
delay.
= FIO-01 or FIO-11)
delay.
= FIO-01)
= FIO-11 or FAIO-01)
selection.
warning.
(A8A0 AI supervision) and freezes
Def/FbEq16
Input
0
1
Not
energized
0.00 s
10 = 1 s
0.00 s
10 = 1 s
0.00 s
10 = 1 s
0.00 s
10 = 1 s
Input
0
1
No action
0
1
2
3