ABB +N5600 Firmware Instructions page 304

304 Parameters
No. Name/Value
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
FBA A MCW bit 7
EFB MCW bit 7
Other [bit]
31.12 Autoreset selection
Bit Fault
0 Overcurrent
1 Overvoltage
2 Undervoltage
3 AI supervision fault
4 Supply unit
5...7 Reserved
8 Application fault 1 (defined in the application program)
9 Application fault 2 (defined in the application program)
10 Selectable fault (see parameter
11 External fault 1 (from source selected by parameter
12 External fault 2 (from source selected by parameter
13 External fault 3 (from source selected by parameter
14 External fault 4 (from source selected by parameter
15 External fault 5 (from source selected by parameter
0000h...FFFFh
Description
1.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Control word bit 7 received through fieldbus interface A.
Control word bit 7 received through the embedded fieldbus
interface.
Source selection (see Terms and abbreviations
Selects faults that are automatically reset. The parameter is a
16-bit word with each bit corresponding to a fault type.
Whenever a bit is set to 1, the corresponding fault is
automatically reset.
The number and interval of reset attempts are defined by
parameters 31.14...31.16.
WARNING! Before you activate the function, make
sure that no dangerous situations can occur. The
function resets the drive automatically and continues
operation after a fault.
Notes:
• The autoreset function is only available in external control;
see section Local control vs. external control
• Faults related to the Safe torque off (STO) function cannot
be automatically reset.
The bits of this binary number correspond to the following
faults:
31.13 User selectable
Automatic reset configuration word.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
on page 148). -
(page 24).
fault)
31.01 External event 1
31.03 External event 2
31.05 External event 3
31.07 External event 4
31.09 External event 5
Def/FbEq16
1
2
3
4
5
6
7
10
11
30
32
0000h
source)
source)
source)
source)
source)
1 = 1