Automatic Fault Resets - ABB +N5600 Firmware Instructions

120 Program features
Monitored signal (37.02)
37.31 (%)
37.21 (%)
37.11 (rpm)
37.16 (Hz)
The action (none, warning or fault) taken when the signal exits the allowed operation
area can be selected separately for overload and underload conditions (parameters
37.03 and 37.04 respectively). Each condition also has an optional timer to delay the
selected action (37.41
Settings
Parameter group 37 User load curve


Automatic fault resets

The drive can automatically reset itself after overcurrent, overvoltage, undervoltage
and external faults. The user can also specify a fault (excluding Safe torque off
related faults) to be reset automatically.
By default, automatic resets are off and must be specifically activated by the user.
WARNING! Before you activate the function, make sure that no dangerous
situations can occur. The function resets the drive automatically and continues
operation after a fault.
Settings
Parameters 31.12...31.16
OVERLOAD
ALLOWED
OPERATION
UNDERLOAD
37.12
37.17
and 37.42).
(page 338).
(page 304).
37.13 37.14 37.15
37.18 37.19 37.20
37.35 (%)
37.25 (%)
Speed
Frequency