ABB +N5600 Firmware Instructions page 389

No. Name/Value
58.16 Communication
loss time
0.0 ... 6000.0 s
58.17 Transmit delay
0...65535 ms
58.18 EFB control word
0000h...FFFFh
58.19 EFB status word
0000h...FFFFh
58.25 Control profile
ABB Drives
Transparent
58.26 EFB ref1 type
Auto
Transparent
General
Torque
Speed
Frequency
58.27 EFB ref2 type
Description
Sets a timeout for EFB communication. If a communication
break lasts longer than the timeout, the action specified by
parameter 58.14 Communication loss action
Changes to this parameter take effect after the control unit is
rebooted or the new settings validated by parameter
Communication control.
See also parameter 58.15 Communication loss
EFB communication timeout.
Defines a minimum response delay in addition to any fixed
delay imposed by the protocol.
Changes to this parameter take effect after the control unit is
rebooted or the new settings validated by parameter
Communication control.
Minimum response delay.
Displays the raw (unmodified) control word sent by the
Modbus controller to the drive. For debugging purposes.
This parameter is read-only.
Control word sent by Modbus controller to the drive.
Displays the raw (unmodified) status word sent by the drive to
the Modbus controller. For debugging purposes.
This parameter is read-only.
Status word sent by the drive to the Modbus controller.
Defines the control profile used by the protocol.
ABB Drives profile (with a 16-bit control word) with registers in
the classic format for backward compatibility.
Transparent profile (16-bit or 32-bit control word) with
registers in the classic format.
Selects the type and scaling of reference 1 received through
the embedded fieldbus interface.
The scaled reference is displayed by
Type and scaling are chosen automatically according to
which reference chain (see settings Torque, Speed,
Frequency) the incoming reference is connected to. If the
reference is not connected to any chain, no scaling is applied
(as with setting Transparent).
No scaling is applied.
Generic reference with a scaling of 100 = 1 (ie. integer and
two decimals).
The scaling is defined by parameter
The scaling is defined by parameter
The scaling is defined by parameter
Selects the type and scaling of reference 2 received through
the embedded fieldbus interface.
The scaled reference is displayed by
For the selections, see parameter
Parameters 389
is taken.
58.06
mode.
58.06
03.09 EFB reference
46.03 Torque scaling.
46.01 Speed scaling.
46.02 Frequency scaling. 5
03.10 EFB reference
58.26 EFB ref1 type.
Def/FbEq16
3.0 s
1 = 1
0 ms
1 = 1
-
1 = 1
-
1 = 1
ABB Drives
0
2
Auto
1.
0
1
2
3
4
Torque
2.