ABB +N5600 Firmware Instructions page 480

480 Parameters
No. Name/Value
Chinese (Simplified,
PRC)
Türkçe
96.02 Pass code
0...99999999
96.03 Access levels
active
Bit Name
0 End user
1 Service
2 Advanced programmer
3...10 Reserved
11 OEM access level 1
12 OEM access level 2
13 OEM access level 3
14 Parameter lock
15 Reserved
0000h...FFFFh
96.04 Macro select
Done
Factory
Hand/Auto
PID-CTRL
T-CTRL
Sequence control
FIELDBUS
Description
Simplified Chinese.
Turkish.
Pass codes can be entered into this parameter to activate
further access levels (see parameter
active) or to configure the user lock.
Entering "358" toggles the parameter lock, which prevents the
changing of all other parameters through the control panel or
the Drive composer PC tool.
Entering the user pass code (by default, "10000000") enables
parameters 96.100...96.102, which can be used to define a
new user pass code and to select the actions that are to be
prevented.
Entering an invalid pass code will close the user lock if open,
ie. hide parameters 96.100...96.102. After entering the code,
check that the parameters are in fact hidden.If they are not,
enter another (random) pass code.
Note: You must change the default user pass code to
maintain a high level of cybersecurity. Store the code in a safe
place – the protection cannot be disabled even by ABB if the
code is lost.
See also section User lock
Pass code.
Shows which access levels have been activated by pass
codes entered into parameter
This parameter is read-only.
Active access levels.
Selects the application macro. See chapter
macros (page 131) for more information.
After a selection is made, the parameter reverts automatically
to Done.
Macro selection complete; normal operation.
Factory macro (see page 132).
Hand/Auto macro (see page 134).
PID control macro (see page 136).
Torque control macro (see page 140).
Sequential control macro (see page 142).
Reserved.
96.03 Access levels
(page 127).
96.02 Pass code.
Application
Def/FbEq16
2052
1055
0
-
0001h
-
Done
0
1
2
3
4
5
6