ABB +N5600 Firmware Instructions page 420

420 Parameters
No. Name/Value
74.50 Time control enable
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
ESP CW bit 15
Other [bit]
74.51 On time
0.0...90000.0 min
74.52 Off time
0.0...90000.0 min
74.79 Fly-start speed
check
Not selected
Selected
DI1
DI2
DI3
DI4
DI5
DI6
DIO1
DIO2
Description
Defines the source for time control enable signal.
The time control is a sequence of run time and stop time
defined with parameters
Time control enable function is disabled.
Time control enable function is enabled.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
Parameter 74.01 ESP control
enable/disable status of the function.
Source selection (see Terms and abbreviations
Defines the time for the motor to stay ON.
After the ON cycle is over, drive will automatically shut down
and switch to 74.52 Off time
On time.
Defines the time for the motor to stay OFF.
After the OFF cycle is over, drive will automatically shut down
and switch to 74.51 On time
Off time.
Defines the source for the Fly start check enable signal.
The function will check the actual motor speed before making
decision on starting procedure.
If the speed is outside safe-to-restart speed region, then the
control program logic will skip starting routines and get in to
production state from the current motor speed.
Note: This parameter setting has no effect in case parameter
74.30 Speed observer enable
speed check employs backspin observer function to check
the speed. Also, by activating this parameter will delay normal
start of the drive for the time necessary to perform
measurement defined in parameter
delay.
Flying start check function is disabled.
Flying start check function is enabled.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Digital input/output DIO1
Digital input/output DIO2
74.51 On time and 74.52 Off
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
word, bit-15 status controls
on page 148).
counter.
counter.
is ON. Since the Fly-start
74.39 Measurement
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(11.02 DIO delayed status, bit 0).
(11.02 DIO delayed status, bit 1).
Def/FbEq16
ESP CW bit
15
time.
0
1
2
3
4
5
6
7
8
9
10
0.0
1 = 1min
0.00
1 = 1min
Selected
0
1
2
3
4
5
6
7
8
9