Ddcs Communication - ABB +N5600 Firmware Instructions

No. Name/Value
58.105 Data I/O 5
58.106 Data I/O 6
58.107 Data I/O 7
... ...
58.124 Data I/O 24
60
60 DDCS
communication
60.01 M/F communication
port
Not in use
Slot 1A
Slot 2A
Slot 3A
Slot 1B
Slot 2B
Slot 3B
RDCO CH 2
XD2D
Description
Defines the address in the drive which the Modbus master
accesses when it reads from or writes to register address
400005.
For the selections, see parameter
Defines the address in the drive which the Modbus master
accesses when it reads from or writes to register address
400006.
For the selections, see parameter
Parameter selector for Modbus register address 400007.
For the selections, see parameter
...
Parameter selector for Modbus register address 400024.
For the selections, see parameter
DDCS communication configuration.
The DDCS protocol is used in the communication between
• drives in a master/follower configuration (see page 68),
• the drive and an external controller such as the AC 800M
(see page 75), or
• the drive (or more precisely, an inverter unit) and the
supply unit of the drive system (see page 77).
All of the above utilize a fiber optic link which also requires an
FDCO module (typically with ZCU control units) or an RDCO
module (with BCU control units). Master/follower and external
controller communication can also be implemented through
shielded twisted-pair cable connected to the XD2D connector
of the drive.
This group also contains parameters for drive-to-drive (D2D)
communication supervision.
Selects the connection used by the master/follower
functionality.
None (communication disabled).
Channel A on FDCO module in slot 1 (with ZCU control unit
only).
Channel A on FDCO module in slot 2 (with ZCU control unit
only).
Channel A on FDCO module in slot 3 (with ZCU control unit
only).
Channel B on FDCO module in slot 1 (with ZCU control unit
only).
Channel B on FDCO module in slot 2 (with ZCU control unit
only).
Channel B on FDCO module in slot 3 (with ZCU control unit
only).
Channel 2 on RDCO module (with BCU control unit only).
Connector XD2D.
Note: This connection cannot co-exist, and is not to be
confused with, drive-to-drive (D2D) communication
implemented by application programming (detailed in Drive
application programming manual (IEC 61131-3),
3AUA0000127808 [English]).
Parameters 393
58.101 Data I/O 1.
58.101 Data I/O 1.
58.101 Data I/O 1.
58.101 Data I/O 1.
Def/FbEq16
Act1 16bit
Act2 16bit
None
...
None
Not in use
0
1
2
3
4
5
6
12
7