Fault Tracing; What This Chapter Contains; Safety; Indications - ABB +N5600 Firmware Instructions

Single drive

Table of Contents

Fault tracing

The chapter lists the warning and fault messages including possible causes and

corrective actions. The causes of most warnings and faults can be identified and

corrected using the information in this chapter. If not, an ABB service representative

should be contacted.

Warnings and faults are listed below in separate tables. Each table is sorted by

warning/fault code.

WARNING! Only qualified electricians are allowed to service the drive. Read

the Safety instructions on the first pages of the Hardware manual before

working on the drive.

Warnings and faults indicate an abnormal drive status. The codes and names of

active warnings/faults are displayed on the control panel of the drive as well as the

Drive composer PC tool. Only the codes of warnings/faults are available over

Warnings do not need to be reset; they stop showing when the cause of the warning

ceases. Warnings do not latch and the drive will continue to operate the motor.

Faults do latch inside the drive and cause the drive to trip, and the motor stops. After

the cause of a fault has been removed, the fault can be reset from a selectable

Fault tracing 565

Show Quick Links

Table of Contents