ABB +N5600 Firmware Instructions page 394

394 Parameters
No. Name/Value
60.02 M/F node address
1...254
60.03 M/F mode
Not in use
DDCS master
DDCS follower
D2D master
D2D follower
DDCS forcing
D2D forcing
60.05 M/F HW connection
Ring
Star
60.07 M/F link control
1...15
Description
Selects the node address of the drive for master/follower
communication. No two nodes on-line may have the same
address.
Note: The allowable addresses for the master are 0 and 1.
The allowable addresses for followers are 2...60.
Node address.
Defines the role of the drive on the master/follower or drive-
to-drive link.
Master/follower functionality not active.
The drive is the master on the master/follower (DDCS) link.
The drive is a follower on the master/follower (DDCS) link.
The drive is the master on the drive-to-drive (D2D) link.
Note: This setting is only to be used with D2D communication
implemented by application programming. If you are using the
master/follower functionality (see page 68) through the XD2D
connector, select DDCS master
The drive is a follower on the drive-to-drive (D2D) link.
Note: This setting is only to be used with D2D communication
implemented by application programming. If you are using the
master/follower functionality (see page 68) through the XD2D
connector, select DDCS follower
The role of the drive on the master/follower (DDCS) link is
defined by parameters 60.15 Force master
follower.
The role of the drive on the drive-to-drive (D2D) link is defined
by parameters 60.15 Force master
Note: This setting is only to be used with D2D communication
implemented by application programming. If you are using the
master/follower functionality (see page 68) through the XD2D
connector, select DDCS forcing
Selects the topology of the master/follower link.
Note: Use the setting Star
functionality (see page 68) through the XD2D connector (as
opposed to a fiber optic link).
The devices are connected in a ring topology. Forwarding of
messages is enabled.
The devices are connected in a star topology (for example,
through a branching unit). Forwarding of messages is
disabled.
Defines the light intensity of the transmission LED of RDCO
module channel CH2. (This parameter is effective only when
parameter 60.01 M/F communication port
2. FDCO modules have a hardware transmitter current
selector.)
In general, use higher values with longer fiber optic cables.
The maximum setting is applicable to the maximum length of
the fiber optic link. See
master/follower link (page 74).
Light intensity.
instead.
instead.
and
and 60.16 Force
instead.
if using the master/follower
is set to
Specifications of the fiber optic
Def/FbEq16
1
Not in use
0
1
2
3
4
5
60.16 Force
6
follower.
Ring
0
1
10
RDCO CH