Setting A Bus Connection - Mitsubishi Electric C70 Setup Manual

MITSUBISHI CNC
2 GOT Initial Setup

2.2.2.3 Setting a bus connection

This section explains the setting procedure for bus connection of GOT1000 Series GT15/16.
Mount the bus communication unit on the GOT rear slot, and then connect it with the bus connection cable.
GT Designer2
(Note) Mount the bus communication unit GT15-QBUS on the GOT rear slot IF-1. When mounting the unit on
the GOT rear slot IF-2, set the "Extend I/F-2" items in later communication setting.
This is how to set without "New Project Wizard" on GT Designer2.
The following example is for GT15. The same setting procedure applies for GT16.
(1) Start GT Designer2. Select "New". Or open the project which is already created. The "System Environment"-
"System Settings" dialog box will appear.
42
or
USB
GT09-C20USB-5P
GT09-C30USB-5P
Rear view
Bus connection
unit
GT15-75QBUS /
GT15-75QBUS2
IF-1 IF-2
GOT1000 Series
(SVGA / XGA)
GT15-QCxxB