Mitsubishi Electric C70 Setup Manual page 228

【#1284(PR)】 ext20
bit0: Spindle speed clamp check
Select whether to check the spindle speed clamp under the constant surface speed control.
0: Check the spindle speed clamp.
1: Not check the spindle speed clamp.
(Note) This parameter is enabled when the parameter "#1146 Sclamp" is set to "1".
【#1287(PR)】 ext23
bit4: Relative coordinate counter display
(M system)
0: Display the position on the program including tool length compensation.
1: Display the position on the program excluding tool length compensation.
(L system)
0: Display the position on the program including tool shape compensation.
1: Display the position on the program excluding tool shape compensation.
bit5: Relative coordinate counter display
(M system)
0: Display the position on the program including tool radius compensation.
1: Display the position on the program excluding tool radius compensation.
(L system)
0: Display the position on the program including nose R compensation.
1: Display the position on the program excluding nose R compensation.
bit6: Workpiece coordinate counter display
(M system)
0: Display the position on the program including tool length compensation.
1: Display the position on the program excluding tool length compensation.
(L system)
0,1: Display the position on the program which excludes tool shape compensation.
This display is also registered to the values of the system variables #5041 and after.
bit7: Workpiece coordinate counter display
(M system)
0: Display the position on the program including tool radius compensation.
1: Display the position on the program excluding tool radius compensation.
(L system)
0: Display the position on the program including nose R compensation.
1: Display the position on the program excluding nose R compensation.
This display is also registered to the values of the system variables #5041 and after.
【#1300(PR)】 ext36
bit7: Spindle synchronization command method
Select the command method for spindle synchronization control.
0: Spindle synchronization control II
1: Spindle synchronization control I
【#1301】 nrfchk Near reference position check method
Select the method to judge the "near reference position".
0: Conventional judging method using command type machine position
1: High-speed judging method using command type machine position
2: High-speed judging method using feedback position
【#1302】 AutoRP Automatic return by program restart
0: Move the system manually to the restart position and then restart the program. (Automatic return
1: The system automatically moves to the restart position at the first activation after the program
(Controlled by PLC)
(Controlled by G code)
is unavailable.)
restarts. (Manual return is also available.)
Appendix 1.3 Base Specifications Parameters
C70 Setup Manual
211