Mitsubishi Electric C70 Setup Manual page 101

MITSUBISHI CNC
4 CNC CPU Initial Setup
(3) The screen to select the communication driver to communicate with the GOT appears. Select "E71 Connection".
Select "Q BUS" for bus connection.
For E71 Connection, refer to the following chapters.
For GT Designer3: 2.1.2.1 to 2.1.2.2
For GT Designer2: 2.2.2.1 to 2.2.2.2
For Bus Connection, refer to the following chapters.
For GT Designer3: 2.1.2.3
For GT Designer2: 2.2.2.3
(When the power is turned ON for the second time onwards, this communication selection screen won't be listed
among the CNC monitor screen selections.)
(4) Select [TOOL PARAM]--->[MENU (MENU 5)]--->[SETUP (MENU 4)] to display the setup screen selection.
(5) By following the screen's instruction, select "Y" ---> "INPUT" (input "Y"), and select "MULTI (MENU 4)".
(Note 1) The display language will change to English after a SRAM clear. Select the display language by the parameter
"#1043 Lang".
(Note 2) When the parameter "#1138 Pnosel" is set to "1", the function to select a screen by parameter will become
valid.
84
>>
>>