Appendix 1.3 Base Specifications Parameters - Mitsubishi Electric C70 Setup Manual

Appendix 1.3 Base Specifications Parameters

The parameters with "(PR)" requires the CNC to be turned OFF after the settings. Turn the power OFF and ON to enable
the parameter settings.
【#1001(PR)】 SYS_ON System validation setup
Select the existence of PLC axes and part systems.
0: Not exist
1: Exist
【#1002(PR)】 axisno Number of axes
Set the number of control axes and PLC axes.
Up to 16 axes, including the number of spindles (in "#1039 spinno"), can be set.
Control axis: 0 to 8
PLC axis: 0 to 8
When set to "0", the number of control axes in the part system will be "0". "1" or more control axes
must be set for the 1st part system.
【#1003(PR)】 iunit Input setup unit
Select the input setting increment for each part system and PLC axis.
The parameter setting increment will follow this specification.
B : 1μm
C : 0.1μm
【#1013(PR)】 axname Axis name
Set each axis' name with an alphabetic character.
Use the characters X, Y, Z, U, V, W, A, B or C.
(Note 1) Do not set the same name twice in one part system.
(Note 2) The PLC name does not need to be set. (Numbers 1 and 2 are shown as the axis names.)
---Setting range---
X,Y,Z,U,V,W,A,B,C
【#1014(PR)】 incax Increment command axis name
Set the axis name when commanding an incremental value for the axis travel amount.
Available alphabets are the same as in "#1013 axname".
(Note 1) Set an alphabet that is different from that of "#1013 axname".
(Note 2) Setting is not required if absolute/incremental specification with axis names is not
---Setting range---
X, Y, Z, U, V, W, A, B, C
【#1015(PR)】 cunit Program command unit
Set the minimum increment of program travel command.
When set to "0", it becomes 0.001mm(1μm).
cunit Travel amount for travel command 1
1: 0.0001 mm (0.1μm)
10: 0.001 mm (1μm)
100: 0.01 mm (10μm)
1000: 0.1 mm (100μm)
10000: 1.0 mm
If there is a decimal point in travel command, the decimal point position will be handled as 1mm
regardless of this setting.
【#1016(PR)】 iout Inch output
Select the unit system used for setting mechanical values (ball screw pitch and position detection
unit).
0 : Metric system
1 : Inch system
The same name which is used in another part system can be set.
performed ("#1076 Abslnc" = "0").
Appendix 1.3 Base Specifications Parameters
C70 Setup Manual
177