Mitsubishi Electric C70 Setup Manual page 282

bit F-8 : amp(bit F-C) / rtyp(bit B-8)
Resistor built-in drive unit
Setting prohibited
MR-RB032
MR-RB12 or GZG200W39OHMK
MR-RB32 or GZG200W120OHMK 3 units connected in parallel : 14
MR-RB30 or GZG200W39OHMK 3 units connected in parallel : 15
MR-RB50 or GZG300W39OHMK 3 units connected in parallel : 16
MR-RB31 or GZG200W20OHMK 3 units connected in parallel : 17
MR-RB51 or GZG300W20OHMK 3 units connected in parallel : 18
Setting prohibited
Setting prohibited
FCUA-RB22
FCUA-RB37
FCUA-RB55
FCUA-RB75/2
Setting prohibited
R-UNIT2
Setting prohibited
FCUA-RB75/2 2 units connected in parallel : 2D
FCUA-RB55 2 units connected in parallel
Setting prohibited
bit 7-4 : emgx External emergency stop function
Set the external emergency stop function.
0: Disable 4: Enable
bit 3-0 :
Not used. Set to "0".
【#2237】 SV037 JL Load inertia scale
Set the motor axis conversion total load inertia including motor itself in proportion to the motor
inertia.
SV037(JL)=(Jm+Jl)/Jm×100
Jm: Motor inertia
Jl: Motor axis conversion load inertia
For linear motor, set the gross mass of the moving sections in kg unit.
<<Drive monitor load inertia ratio display>>
Set SV035/bitF=1 and imbalance torque and friction torque to both SV032 and SV045, and then
repeat acceleration/deceleration for several times.
---Setting range---
For general motor: 0 to 5000 (%)
For linear motor 0 to 5000 (kg)
【#2238】 SV038 FHz1 Notch filter frequency 1
Set the vibration frequency to suppress when machine vibration occurs.
(Normally, do not set 80 or less.)
Set to "0" when not using.
Related parameters: SV033/bit3-1, SV115
---Setting range---
0 to 2250 (Hz)
【#2239】 SV039 LMCD Lost motion compensation timing
Set this when the timing of lost motion compensation type 2 does not match.
Adjust increments of 10 at a time.
---Setting range---
0 to 2000 (ms)
Appendix 1.5 Servo Parameters
: 10
: 11
: 12
: 13
: 19-1F
: 20-23
: 24
: 25
: 26
: 27
: 28
: 29
: 2A-2C
: 2E
: 2F
C70 Setup Manual
265