Mitsubishi Electric C70 Setup Manual page 199

MITSUBISHI CNC
Appendix 1 Explanation of Parameters
【#1060】 SETUP Activate setup processing
Execute the functions required for initializing the system.
To initialize the machining program file
and tool offset file
The above files are initialized and the standard
fixed cycle program is input
(Note) Most setup parameters will be initialized with one-touch setup. So confirm the data before
【#1061(PR)】 intabs Manual ABS updating
Select whether to update the absolute position data during automatic handle interrupt.
This parameter is enabled only when "#1145 l_abs" is set to "1".
0: Do not update (coordinate system shifted the amount of the interruption)
1: Update (same coordinates as when interrupt did not occur will be applied)
【#1062】 T_cmp Tool compensation function
Select whether the tool length compensation and wear compensation are enabled during T
command execution.
0 : Tool length compensation enable
1 : Tool length compensation enable
2 : Tool length compensation disable
3 : Tool length compensation disable
【#1063】 mandog Manual dog-type
Select the manual reference position return method for the second return (after the coordinate
system is established) and later.
The initial reference position return after the power ON is performed with dog-type return, and the
coordinate system will be established.
(This setting is not required when the absolute position detection is used.)
0: High speed return
1: Dog-type
【#1064(PR)】 svof Error correction
Select whether to correct the error when the servo is OFF.
0: Not correct the error
1: Correct the error
182
1:Execute one-touch setup
#(1060) Data ( 1) ( )
"Standard parameter setting? (Y/N)" is displayed
To initialize the parameters
Y INPUT
The parameter are initialized according to
the setting value in #1001 #1043
"Format? (Y/N)" is displayed
Y INPUT
"Setup complete" is displayed
executing.
This parameter will automatically be set to 0 when the power is turned ON.
INPUT
To retain the current parameters
N
INPUT
To retain the current machining program
file and tool offset file
N INPUT
Wear compensation enable
Wear compensation disable
Wear compensation enable
Wear compensation disable