Table of Contents
Advertisement
MITSUBISHI CNC
2 GOT Initial Setup
2.1 GT Designer3
Transfer the project data, where required settings have been made, to GOT.
2.1.1 Installing GT Designer3
(1) Install GT Designer3 to the personal computer.
(Note)
GT Designer3 Version 1.37P or later is required.
(2) Connect the personal computer to GOT with a USB cable or prepare a CF card.
GT Designer3
(Note 1) When connected to the GOT for the first time, the "Found New Hardware Wizard" screen may
appear. Make a selection for the "What do you want the wizard to do?" question, and click "Next" to
install the hardware.
If you select "Install from a list or specific location" for the "What do you want the wizard to do?"
question, select as below: C:MELSEC\Easysocket\USBDrivers\ECUsbd.sys
(Note 2) Format a CF card in FAT(FAT16) format with the personal computer before using the card. Data
may not be transferred to GOT if the memory card has any folder/file which is not related to GOT.
(Note 3) Some types of commercially available CF cards performance of which is checked by MITSUBISHI
can be used. For performance-checked types, refer to technical news "List of Valid Devices
Applicable for GOT1000 Series" (GOT-A-0010).
The above technical news is available in the Factory Automation Systems section of MITSUBISHI
ELECTRIC's website.
6
or
USB
GT09-C20USB-5P
GT09-C30USB-5P
GOT1000 Series
(SVGA / XGA)
Advertisement
Table of Contents
Troubleshooting
