Mitsubishi Electric C70 Setup Manual page 556

P486 Milling error
Details
- Cylindrical interpolation or polar coordinate interpolation was commanded during mirror image.
Remedy
- Correct the program.
P487 Travel n/a (mill)
Details
A movement command was issued to a position which is out of the movable range on the polar
coordinate interpolation surface.
Remedy
- Check the machining program, parameters and the amount of tool compensation.
P600 NO AUTO TLM.
Details
An automatic tool length measurement command (G37) was issued though it is out of specifications.
Remedy
- Check the specifications.
P601 NO SKIP SPEC.
Details
A skip command (G31) was issued though it is out of specifications.
Remedy
- Check the specifications.
P602 NO MULTI SKIP
Details
A multiple skip command (G31.1, G31.2 or G31.3) was issued though it is out of specifications.
Remedy
- Check the specifications.
P603 SKIP SPEED 0
Details
The skip speed is "0".
Remedy
- Specify the skip speed.
P604 TLM ILL. AXIS command
Details
No axis was specified in the automatic tool length measurement block. Otherwise, two or more axes
were specified.
Remedy
- Specify only one axis.
P605 T-CMD IN BLOCK
Details
The T code is in the same block as the automatic tool length measurement block.
Remedy
- Specify the T code before the automatic tool length measurement block.
P606 NO T-CMD BEFOR
Details
The T code was not yet specified in automatic tool length measurement.
Remedy
- Specify the T code before the automatic tool length measurement block.
C70 Setup Manual
Appendix 2.13 Program Errors (P)
539